RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

Ground location question

   
Old Jul 29, 2009 | 03:14 PM
Share
  #1  
killerrx710's Avatar
killerrx710
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (8)
 
Joined: Jan 2006
Posts: 449
Likes: 0
From: NY
Ground location question
Putting my swap in and I was wondering where the ground circled in the pic goes to? thanks guys

Reply
0
Old Jul 29, 2009 | 03:53 PM
Share
  #2  
Sled Driver's Avatar
Sled Driver
The Anti-Prius
Tenured Member 20 Years
iTrader: (9)
 
Joined: Feb 2001
Posts: 1,107
Likes: 3
From: Federal Way, WA
On the engine block with the same bolt that hold the rats nest, fuel, water lines. Next to the coil pack.

Do you have the FSM? It shows the wire harness routing in the engine removal/rebuild/install chaper.
Reply
0
Old Jul 29, 2009 | 08:08 PM
Share
  #3  
killerrx710's Avatar
killerrx710
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (8)
 
Joined: Jan 2006
Posts: 449
Likes: 0
From: NY
so there are 2 grounds on the block? i know the ground wire by the water temp sensor also goes on the block
Reply
0
Old Jul 30, 2009 | 12:43 AM
Share
  #4  
Sled Driver's Avatar
Sled Driver
The Anti-Prius
Tenured Member 20 Years
iTrader: (9)
 
Joined: Feb 2001
Posts: 1,107
Likes: 3
From: Federal Way, WA
Originally Posted by killerrx710
so there are 2 grounds on the block? i know the ground wire by the water temp sensor also goes on the block
That's the heavy duty one from the battery.

There are three grounds on the motor if you count the one from the body to the UIM, next to the O2 sensor plug
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
My SA is Famous!
mazdaverx713b
1st Generation Specific (1979-1985)
19
Aug 29, 2015 12:30 PM
new from Calgary
turbo-minivan
Introduce yourself
3
Aug 27, 2015 07:56 AM
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
Diagnostic Connector- Tach/RPM ?


Thread Tools
Search this Thread
Search this Thread:

Advanced Search

Advanced Search

All times are GMT -5. The time now is 02:17 PM.