3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Gremlins in my TPS HELP!!

Thread Tools
 
Search this Thread
 
Old 11-10-02, 06:34 PM
  #1  
Senior Member

Thread Starter
 
karken29's Avatar
 
Join Date: Nov 2002
Location: Morristown, NJ
Posts: 347
Likes: 0
Received 1 Like on 1 Post
Gremlins in my TPS HELP!!

Gremlins are the bain of every shade tree mechanic and I guess I'm no more immune to them than the next person. Since replacing my engine this past week I've been experiencing the following problem.

My TPS (Throttle Position Sensor) isn't working, or so it would appear. It looks like it has received unkind treatment in the past and has sustained some "battle-damage" from less than caring techncian. Anyway, every cycle of the ignition key keeps generating a "Check Engine" Light. When I apply a jumper wire to the diagnostic bus between the ground and ten terminals and cycle the key on, the ECU reports errors for codes #12 & 18. This situtation is placing my engine into "Safe-Mode" which restricts boost to around 7PSI max and operates the primary injectors in "Rich" mode only. BTW I can also duplicate the same code by merely unpluging the harness plug from the TPS and cycling the key on.

Given that I only have 300 Miles approximately, on a new engine, this isn't an entirely bad situation.... for now! However, I would like to get this problem cleared soon for obvious reasons.

Anyone have any suggestions??
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Einheri
Single Turbo RX-7's
14
10-07-15 12:23 PM
GKW
1st Generation Specific (1979-1985)
5
09-28-15 04:34 PM



Quick Reply: Gremlins in my TPS HELP!!



All times are GMT -5. The time now is 09:48 AM.