Greedy Pully Kit
#1
Full Member
Thread Starter
Join Date: Jun 2005
Location: Florida
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
Greedy Pully Kit
Just got the Greddy pully kit and want to install it. I did a search and didn't really find anything. Does anyone have any tips before I start this? Do I need to get block off plates for the air pump if I want to remove it? Anything will help, Thanks
#3
Rotary Enthusiast
Join Date: Feb 2005
Location: Charlotte, NC
Posts: 1,336
Likes: 0
Received 0 Likes
on
0 Posts
If you don't want to take the time to install the block-off plates, you can just buy some rubber caps that fit on the end of the hard lines that attach to the manifold. Rob Robinette has a write-up on his site about this way of doing that. http://www.robrobinette.com/air_pump.htm
#5
white FD lover
Join Date: Feb 2003
Location: central jerzy
Posts: 1,534
Likes: 0
Received 0 Likes
on
0 Posts
its easy man theres really no help to give. unbolt them and put the new ones on, if your doing the MAIN pulley then yea you need to take your time but I don't believe the Greddy kit is the main pulley. You can leave the airpump on the car if you want and just run the caps, but your wasting about 25 lbs of weight there.
#6
White is tight
Join Date: Sep 2002
Location: Tucson, AZ
Posts: 1,208
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Mp0629
As far as installing the pulley's, any help there?
its mandatory to remove the airpump with this kit.
no you cant just take it off either.
no you cant just take it off either.
Last edited by fdeeznutz; 08-20-05 at 12:57 PM.
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM