I decided to install a ss clutch line and rebuild my master. Pulling the old clutch line ended up being a pita and the new ss line from mazdatrix seems to be much longer than necessary..

Everything technically worked fine before I touched it. I just thought clutch was a little easy to push compared to my friends fd so I figured a rebuild would help (60k miles)

Well, now, after one push, clutch only comes back halfway (these are quick pushes) 2nd push comes back quarter, and third push sticks to the floor... Did I screw up the rebuild? screw up the ss install? leak? or my slave went out... Maybe just air still in the lines? I can pull up the clutch and it does the same thing.

 

Sounds like you need to bleed the system properly.

 

really? I'll try bleed again. If that's it, I'll be ecstatic.

 

I rebled and still having issues. If I hold the pump down for a few seconds and then let go, it stays on the floor. If I pump quickly, it comes back up. Would this be the master or the slave?