3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Fueling or firing issues?

Thread Tools
 
Search this Thread
 
Old Nov 29, 2010 | 12:05 AM
  #1  
orangeapeel's Avatar
Thread Starter
No more pistons!
 
Joined: Sep 2010
Posts: 23
Likes: 0
From: Fort Worth, TX
TX Fueling or firing issues?

Not sure what is going on with my rex, but here is the back story. I moved on November 7th and the car sat in the driveway for 5 days at the new house. It has a remote start on it and I used to be able to hear it fire right up at my old house in the garage. Well, this time the weather must have changed enough to where it was turning over but wasnt getting spark or fuel (one or the other). When I went outside I noticed that the car was not started and i could smell unburnt fuel. I figured that it probably just hosed down the plugs and flooded so it would need to sit overnight to dry up. I go to start it the next day and the battery is dead. I got another battery and now its back to turning over but not firing. I can hear an occasional pop out the exhaust like its about to start. It is on the ragged edge of firing up. Can you usually hear the fuel pump prime when you turn the key to "on" with these cars? I can't hear anything, but never payed attention to whether or not it had a whiney prime before. It has a Walbro 255lph pump.

I was almost thinking maybe i need to just pull the plugs and either air it out or change/check them since they would be out anyway. The car had been running pig rich according to the wideband before so maybe my plugs are fouled.

Would ether spray be a bad idea since its EFI?

Any input would be greatly appreciated!
Reply
Old Nov 29, 2010 | 11:24 AM
  #2  
zxrazorxz's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Aug 2008
Posts: 349
Likes: 0
From: campbell river british columbia
it sunds as if its severly flooded. take the plugs ut unplug the fuel pump relay crank for fifteen seconds or more put oil in the leading holes turn it over by hand to lub the apex seals then install new plugs see if it will fire.. also if it does get your oil changed
Reply
Old Dec 1, 2010 | 11:52 PM
  #3  
orangeapeel's Avatar
Thread Starter
No more pistons!
 
Joined: Sep 2010
Posts: 23
Likes: 0
From: Fort Worth, TX
I will have to try that tomorrow. Thanks for the tips.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Queppa
New Member RX-7 Technical
11
Nov 18, 2024 03:47 AM
Rotospectre
New Member RX-7 Technical
3
Mar 28, 2018 03:33 PM
stickmantijuana
Microtech
30
Apr 23, 2016 06:37 PM
diabolical1
2nd Generation Specific (1986-1992)
30
Jan 30, 2016 05:50 AM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM




All times are GMT -5. The time now is 09:55 AM.