ok well rebuild is in and cars been sitting for a while and when i turn on the ignition to run the fuel pump does not kick on. if i jumper the fp and gnd in the diagnostic and then turn on the key it runs fine.. soo am i missing a plug somewhere? or did a wire get chewed.. i checked the main and fp relays under the hood and there fine, react with 12v and open and close circuit fine. fuel pump fuse under dash is fine too. starter cranks over, no codes other then airbag light blinking 3 times. im lost at the moment. if i have to ill run a line to a manual switch for the pump but i need to know where to run it from. i cant seem to make out where all the connections are.
did full emmisions removal and non sequential.

any info would be awsome at this point. im at a complete stand still and am very desperate to get my car goin again.
please and thank you!

-Ric.

 

bump

 

is it maybe my ecu is done? can i bypass the ignition circuit and just do the fuel pump rewire?. what other connectors are associated with the fuel pump with pulling the engine and removing the sequential and emissions stuff?.
anything helps.