Front Lower Cross Brace - What's the Part Number
#1
Front Lower Cross Brace - What's the Part Number
Can someone help me with the part number for this front lateral brace? It's the bolt in brace just in front of the crank pulley. It looks like the battery leaked at some point in the past and some yahoo spliced in a 2x4 to repair it. YGBSM.
#2
RX-7 Bad Ass
iTrader: (55)
That joker was WAY harder to find in the parts diagram than I would have guessed!
FD01-56-290A
Looks like $60ish dollars.
You can also get them used, shouldn't be too hard or costly to get used. Many of them have surface rust from the battery, some cleanup work, rust neutralizer, and a good coat of paint can do wonders.
I made my own out of an L-shaped piece of aluminum from McMaster-Carr. I had to modify it a lot to fit my front mount so I just made a new one and had it powdercoated.
Dale
FD01-56-290A
Looks like $60ish dollars.
You can also get them used, shouldn't be too hard or costly to get used. Many of them have surface rust from the battery, some cleanup work, rust neutralizer, and a good coat of paint can do wonders.
I made my own out of an L-shaped piece of aluminum from McMaster-Carr. I had to modify it a lot to fit my front mount so I just made a new one and had it powdercoated.
Dale
The following users liked this post:
gracer7-rx7 (07-30-17)
#3
That joker was WAY harder to find in the parts diagram than I would have guessed!
FD01-56-290A
Looks like $60ish dollars.
You can also get them used, shouldn't be too hard or costly to get used. Many of them have surface rust from the battery, some cleanup work, rust neutralizer, and a good coat of paint can do wonders.
I made my own out of an L-shaped piece of aluminum from McMaster-Carr. I had to modify it a lot to fit my front mount so I just made a new one and had it powdercoated.
Dale
FD01-56-290A
Looks like $60ish dollars.
You can also get them used, shouldn't be too hard or costly to get used. Many of them have surface rust from the battery, some cleanup work, rust neutralizer, and a good coat of paint can do wonders.
I made my own out of an L-shaped piece of aluminum from McMaster-Carr. I had to modify it a lot to fit my front mount so I just made a new one and had it powdercoated.
Dale