Is anyone running the FFE rails with an air control valve.

I'm ordering my fuel system now and looking to go Adaptronic ECU as well. The Adaptronic ECU needs the ISC. I understand most single builds block off the ACV with a plate which would allow the FFE secondary rails to fit, but maybe I'm missing something.

Is there a way to make it fit maybe with different sized FFE rails? I see the FFE Rails come in 60mm, 44mm and 34mm. Would one of those work with ID 2000 injectors. I don't believe ID 2000's come in 34mm.

Any help is appreciated.

 

The ISC and ACV are two separate things. ACV is on the lower intake manifold on the inside and controls where air pump air goes for emissions. The ISC is on the back of the upper intake manifold, out of the way of the fuel injectors, and controls idle speed.

Dale

 

Ok so it is a non issue then. Thanks for clearing it up. I had tried to do a little searching on ACV and ISC and had concluded they were one in the same. I should have looked harder.. i now see there are block off plates for both.

Thanks!

 

The ID2000's are 34mm so not an issue with the ACV valvle.

 

^^^ So you're saying the rail will fit with the ACV in place (using the ID2000's)?