FD wastegate actuator?
Rotary Freak
Joined: Jun 2005
Posts: 1,679
Likes: 288
From: sydney
As in non-oem? Turbosmart make a universal type, that should be able to be made fit the existing mount with a bit of work when I checked the dimensions last. The mong over here doing improved twins was using Forge units on his a while back.
Joined: Nov 2011
Posts: 3,425
Likes: 489
From: okinawa to tampa
Thread Starter
Junior Member
Joined: May 2019
Posts: 16
Likes: 0
From: Idaho
I have OEM turbos still. I have discovered that my wastegate isnt holding boost because the actuator seems to be worn out. I’m trying to avoid going after market and needing to build a bracket.
When I ported the FD twins center turbo piece and cut-back the downpipe flange to allow the internal wastegate flapper arm to open further I found the stock actuator did not have enough throw to open the flapper all the way.
I watched so.e youtube vids to choose an aftermarket actuator that had more throw and bought the Kinugawa SR20 kit. It had pieces that allowed it to fit up, though I had to fab up a simple WG bracket where it mounts to the compressor housing.
Not sure if you are looking for stock or looking for an aftermarket one like I was.
I watched so.e youtube vids to choose an aftermarket actuator that had more throw and bought the Kinugawa SR20 kit. It had pieces that allowed it to fit up, though I had to fab up a simple WG bracket where it mounts to the compressor housing.
Not sure if you are looking for stock or looking for an aftermarket one like I was.
Thread
Thread Starter
Forum
Replies
Last Post