EviLPeNeviL

iTrader: (2)

After getting my car back from the body shop, I start the car with no problems, after a few min the ABS light would come on.

The upper control arm got replaced, the front passenger side wheel area got jacked up and pushed due to the accident, but all that was fixed and everything has been installed back to stock settings.

I checked the brake/slave cylinder and the fluid seems to be pretty full. The car drives PRETTY good, alignment was done, but it pulls to the right a tiny bit, so I'll have to get that checked. Other than that the car drove fine.

Any ideas about the ABS light?

Thanks.

-Dan

Little 7

I got same problem happen on my BMW. Check the ABS sensor wire is on the correct position. My ABS light happend when I made a left U turn. So, check it first for Right and Left side.

poss

iTrader: (5)

does it only turn on when you start to move (10ft or so)? if so, I'd be fairly certain that it's your passenger side ABS sensor. The connector for it is mounted to the fender, right behind of the shock tower. you can disconnect it and check it with an ohm meter. You'll have to double check the manual to see what it is supposed to read, but for some reason 800-1.3k ohms sticks out in my head.
good luck.