hey guys i need to know exactly where the coolant buzzer is on the fd.
i broke the water level sensor wire. i ordered it but i need to drive to a car show on Tuesday and it gives me the biggest headache driving it for even 5 min. And the show is 2 hours away!!!
Please help
thanks

 

Just ground the wire....or better yet get a new sensor

 

i broke the wire in a bad place. i ordered a new sensor but i need a temporary fix.
do you know where the buzzer is?

 

In the vicinity of your A/C compressor and PS pump, there is a black single wire blade-style male and female connector pair. Unplug them. Make a jumper wire with a female blade, stick it on the male side (this is the side that does not go to the sensor, but to the harness) and run it to a ground. This will make the coolant buzzer circuit think that the sensor is immersed in coolant.

You can't just disable the buzzer by itself without turning off a lot of other things, or ruining your CPU2 module (or I should say, it would be ruined if you didn't solder the buzzer back on to the circuit board after removing it.)

You can turn the buzzer off by unplugging the large connector that sticks out of the middle of the CPU2, but you'll be turning other stuff off in the process. So do what I said above, but remember to fix it properly later.

 

i will. also would my buzzer go off if my oil pan level sensor is unplugged to?
i just rebuilt the motor and those happen to be the two things i broke. /
if so then how can i trick the sytem for that too?
thank you for help, finally someone gives me good advice ^ lol