ZeroBanger

I would like to attach my dyno sheet, but when I attach a pic, it just shows up as a link...how do I attach as a pic?

R Xplicit

go to the body of the massage, and cut and paste the link. it would need to be hosted ont he internet to work though. here's how it should look


[IMG]insertedlinktopicture[/IMG]

R Xplicit

woops^^^i guess that i illustrated it too well....

brackets [] with IMG before the cut an pasted link and brackets[] with /IMG directly after the pic. no space or anything...

matty

what did your car make?

ZeroBanger

Here is the dyno sheet....

matty

262 rwhp @ what psi?
get a midpipe!!

amp

iTrader: (50)

and what was the temp....

ZeroBanger

I guess I should clarify, I had 5 runs and aborted 2 of them. my intercooler was so hot I could not touch it. We cooled the car down for 20 minutes and ran it again. I freaked out at the transition cause it hit 14 psi and he aborted the run. The guy running the dyno said I would have hit 280 easily. The next run my IC was a heat sink again and did the 265. I did not change the boost for the last run, it hits 14 psi at transition and then went down to 12 ish PSI.

Anyone else find it odd that my power peaks so early and holds till the red line?

Also they shop had a small fan that was about 4 feet away from the car. it was worthless. It was 265.8 HP around 12 PSI (I set my power FC to 80 and 80 for the secondary turbo. My water temp was 108)



David

matty

damn thats a hot *** water temp!

get a midpipe...lol..no seriously mp make so much more power...i ran an fd with same mods as mine but a high flow instead of a mp...we raced from 55mph..i RAN away from him...!

Wargasm

I added your dyno to my page at www.catenet.net/dyno.php

JspecFD

iTrader: (2)

Just attach the image and then get the link address from where the forum hosted it. Then, just edit your message adding in the address for the pic like so:

MazdaMike

whaen u run a dyno hoe many fans do u normally have or does it carey and can u just channel a fan directly to the intercooler port?

ZeroBanger

it was a small fan maybe 30 or 32 inch, sitting about 4 feet away. it wasn't even a breeze. I guess it depends on what shop you use.