I acquired set of fc coils and the ignitor. I'm currently running the stock setup which is starting to act up..

Will the fc ignitor work with the power fc or do I need to use my fd ignitor?

After looking at a few wiring diagrams, I'm a bit confused on which wire to use for the "coil selector". The white wire in the 4 pin connector on the fc ignitor.

Does the power fc lack the switching wire that allows the trailing coil to switch from t1 to t2?

 

Although I don't know the answer to your specific question I can tell you that I ran a second gen leading coil with FD if igniter and a PFC for many years at 24psi without any ignition breakup.

 

you don't need all the FC coils....

just replace the FD leading coil with the FC leading, that's all I did and it works great, no issues...


J.

 

Thanks guys for your help. So I'm going to try replacing just the leading coils and see if that helps.