3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

engine light

Thread Tools
 
Search this Thread
 
Old Oct 17, 2003 | 09:06 PM
  #1  
Talon's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 99
Likes: 0
From: syracuse,ohio
engine light

I have done a search and didn't see anything posted about the engine light never going off. Mine stays on and when i put the clip into the diag tester it won't show codes. Just stays highlighted the whole time.

I am not sure if it stays on while the car is running though b/c my car currently will not start. I was told the ecu might be bad and I am going to try changing it out next week when I have a known working ecu to test with.

Any one had this problem? Or seen a thread that maybe I missed?
Reply
Old Oct 17, 2003 | 09:31 PM
  #2  
911GT2's Avatar
The Power of 1.3
Tenured Member 10 Years
 
Joined: Aug 2001
Posts: 2,837
Likes: 0
From: Shrewsbury, Massachusetts
It should be on when the key is in the on position with the car off. It should be off with the car running, unless theres an issue.
Reply
Old Oct 17, 2003 | 09:34 PM
  #3  
Talon's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 99
Likes: 0
From: syracuse,ohio
Ahh i see now. I was under the impression that it went off when you turned the key to "on" if there was no codes.


Thanks
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Kyo
2nd Generation Specific (1986-1992)
6
Apr 13, 2019 09:24 AM
gtcd
1st Generation Specific (1979-1985)
30
Aug 19, 2015 02:44 AM
Professorpeanutrx7
New Member RX-7 Technical
5
Aug 15, 2015 01:38 PM




All times are GMT -5. The time now is 06:28 AM.