View Poll Results: What do I do?
Advice
0
0%
Help
0
0%
Voters: 0. You may not vote on this poll
Engine Bog down and backfiring
#1
Newbie
Thread Starter
Join Date: Aug 2003
Location: Calgary, Alberta Canada
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Engine Bog down and backfiring
I have had a progressive problem. When my engine heats up to about 96deg it sometimes starts bog down to the point that I have no power and nearly stalls. I have to pump the gas to keep it running but cannot get the RPMs above 4500. While I pump the gas it backfires and does not have enough power to move the car. After a few minutes of looking like an idiot on the side of the street I clear the problem by constantly pumping the gas.
Also I found that when I press the gas the RPMs fluctuate about 700 RPMS. Meaning like it is losing power for a split second and then returns.
Since I have had this problem I have installed:
Upgraded fuel pump
Custom K&N combo intake air box
APexi Power FC
new plugs
new gas filter-pain in the *X*#@ to change
New MAP sensor
New Apexi down pipe
Racing beat exhaust
I have to re-install the old computer to check the codes and it comes up with the MAP sensor, or sometimes nothing.
I have taken this in to my local shop (RX-7 Specialty) and they can't figure this out. I will try the additional grounding but this sounds more severe than hesitation.
Please help!!!!!!
Also I found that when I press the gas the RPMs fluctuate about 700 RPMS. Meaning like it is losing power for a split second and then returns.
Since I have had this problem I have installed:
Upgraded fuel pump
Custom K&N combo intake air box
APexi Power FC
new plugs
new gas filter-pain in the *X*#@ to change
New MAP sensor
New Apexi down pipe
Racing beat exhaust
I have to re-install the old computer to check the codes and it comes up with the MAP sensor, or sometimes nothing.
I have taken this in to my local shop (RX-7 Specialty) and they can't figure this out. I will try the additional grounding but this sounds more severe than hesitation.
Please help!!!!!!
#3
Newbie
Thread Starter
Join Date: Aug 2003
Location: Calgary, Alberta Canada
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I replaced the water thermosensor already. It was one of the codes that come up.
I grounded the battery last night to the engine using some of the recent info in the forum and will test today.
I grounded the battery last night to the engine using some of the recent info in the forum and will test today.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM