Engine bay wiring
#1
New to the Club!
Thread Starter
Join Date: Mar 2022
Location: Alberta
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Engine bay wiring
Hey there, first time post. I bought a rhd 93 rx7, with all the wiring harness removed and sitting in a box. I’ve laid them out and started installing them. The issue I’m running in to is that I’m not sure where most of the sensors etc are located on the engine, as the whole situation is a disaster and I have never owned a rotary car. I was wondering if there was any good posts that could begin to point me in the correct direction. Thanks
#4
Senior Member
iTrader: (16)
http://foxed.ca/indexmobile.php?page=rx7manual
This will get you started. Scroll down to the third gen docs. It’s not rhd specific, but it has a lot of helpful info.
~ GW
This will get you started. Scroll down to the third gen docs. It’s not rhd specific, but it has a lot of helpful info.
~ GW
#5
RX-7 Bad Ass
iTrader: (55)
You also need this -
https://www.rx7club.com/3rd-generati...dex%2A-971065/
That with the shop manual will be a big help.
Dale
https://www.rx7club.com/3rd-generati...dex%2A-971065/
That with the shop manual will be a big help.
Dale
The following users liked this post:
spintowinrx7 (06-09-22)
Thread
Thread Starter
Forum
Replies
Last Post
coolrotariesR1
3rd Generation Specific (1993-2002)
6
06-22-10 05:23 AM