Any advise/tips for putting the rotary back together? Been reading all the threads and have watched a video. Just wanted to see if there was anything else that I should be doing before I assemble. So far I’ve:
Taken everything apart, cleaned it all up with carb cleaner until no carbon is showing on the rotors, apex seals, and side seals.
Checked all the clearances and everything is in spec.
Going to use vaseline on both inner and outer seals.
Using Marvel Mystery Oil for assembly

Anything else?

Thanks in advance

 

Check out nopistons.com in the engine building section im pretty sure they have a whole thread of tips. My tip buy some superglue and watch out some of the edges are really sharp