3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Electrical grounding where to start.

Thread Tools
 
Search this Thread
 
Old Jul 14, 2002 | 03:22 PM
  #1  
Liemoanh's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 158
Likes: 0
From: Denver
Electrical grounding where to start.

My car is hesitating when I drive at night with the lights on. I'm thinking its the grounding. Where can I install and extra grounding on the car? Where are all the electrical groundings on the car? Thanks
Reply
Old Jul 15, 2002 | 04:43 AM
  #2  
duboisr's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 2,171
Likes: 1
From: Nashville Tn
battery to motor ,there is a stud below and foward of the sparkplugs then go from the stud to the front subframe mounting stud (long one near the wheel) use large cable . Then go to the rear engine hoist plate on the uim,use one of the two bolts ,go to the right fender and use a bolt for the abs units mount ,use good size wire
Reply
Old Jul 15, 2002 | 04:48 AM
  #3  
jspecracer7's Avatar
1JZ powered
Tenured Member 10 Years
 
Joined: Jul 2001
Posts: 4,423
Likes: 0
From: Where there's only two seasons, hot and wet! I love Okinawa
I just did an engine pull last week. I put all the ground back in place, but it was have a VERY hard time starting because of bad grounds, so I took 2 gauge wire and ran it from the alternator to the body. No more grounding problems!
Reply
Old Jul 15, 2002 | 11:17 AM
  #4  
Liemoanh's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 158
Likes: 0
From: Denver
Thanks for your help guys. I appreciate it.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
Oct 3, 2015 01:08 AM




All times are GMT -5. The time now is 01:32 PM.