cutting out above 1/4 throttle
Passenger
Posts: n/a
would a check valve be the cause of cutting out above 1/4 throttle? or could it be a problem with the map sensor? when you get any kind of boost it cuts off then on then off thenon ect... ive replaced most the top vacume lines with silicone but diddnt inspect the check valves and it is still doing it, any suggestions to check?
hey mate that sounds like limp mode (safety system programmed into the ECU to stop engine damage when theres an electrical malfunction)),,,, try pulling the ECU codes ,,-> should reveal an electrical sensor fault somewhere.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM



