Confusing flashing while pulling codes
07-26-10, 06:15 PM
#1
Luckily no broken cambelt
Thread Starter
Join Date: Nov 2009
Location: Sweden
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
Confusing flashing while pulling codes
I pulled my codes today (JDM car) and got:
Long flash (~2 sec) 8 short flashes 1 long flash 1 medium long break (~1 sec) 1 medium long flash and the pattern repeated without any break.
I'm confused, this doesn't match the manual
, where is the 4 second break between code cycles. No pause between long and short flashes for the first code. No pause between codes (if there were more than 1 code). Medium long flash, what to say about that?
I'm guessing I have a code 18 (throttle position sensor (narrow)) but what to tell from the rest of the flashing?
Long flash (~2 sec) 8 short flashes 1 long flash 1 medium long break (~1 sec) 1 medium long flash and the pattern repeated without any break.
I'm confused, this doesn't match the manual
, where is the 4 second break between code cycles. No pause between long and short flashes for the first code. No pause between codes (if there were more than 1 code). Medium long flash, what to say about that?I'm guessing I have a code 18 (throttle position sensor (narrow)) but what to tell from the rest of the flashing?
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM