compression Question
#1
Senior Member
Thread Starter
compression Question
hey guys, i 'm currently looking for fd's.... i found one and did a compression test,....found out both rotors are at low 6's.
is this ok? it has 100000 kms.
thanks
is this ok? it has 100000 kms.
thanks
#3
Senior Member
Join Date: Oct 2001
Location: The 'Nati, Ohio
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
Depends at what rpm that was tested at.
6 is the minimum acceptable at 250 rpm...as stated in the shop manual. It it was lower than 250, than lower than 6 is acceptable. However, these are the MINIMUMS acceptable as stated in the shop manual.
If you want a really strong engine, than try to shoot for one in the 7 range.
Later,
Patrick
6 is the minimum acceptable at 250 rpm...as stated in the shop manual. It it was lower than 250, than lower than 6 is acceptable. However, these are the MINIMUMS acceptable as stated in the shop manual.
If you want a really strong engine, than try to shoot for one in the 7 range.
Later,
Patrick
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM