clutch trouble
#1
here to disgrace
Thread Starter
Join Date: Feb 2004
Location: Dallas, Tx
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
clutch trouble
Well yesterday my clutched died
When i press the pedal to the floor it stays there
and dosnt come up.
Also, it wont get into gear when its down either.
Is this a master cylinder or the release cylinder
where is the master cylinder at? right beside and attached to the firewall?
dont really feel like taking the transmission plate off and seeing if the pressure plate is being worked any other way?
When i press the pedal to the floor it stays there
and dosnt come up.
Also, it wont get into gear when its down either.
Is this a master cylinder or the release cylinder
where is the master cylinder at? right beside and attached to the firewall?
dont really feel like taking the transmission plate off and seeing if the pressure plate is being worked any other way?
#2
Fast + Reliable = $$$$$
iTrader: (18)
Had the same problem once...although I was able to grab the pedal and pull it back up. Worked fine a couple of times, eventually it got really bad.
Anyway, it wasn't the clutch itself but the clutch master cylinder. It's under the brake master cylinder against the firewall, shares the same resorvoir as the brake master. Btw, you might want to change the slave cylinder on the tranny at the same time, some folks say that if one goes bad the other should soon as well.
Anyway, it wasn't the clutch itself but the clutch master cylinder. It's under the brake master cylinder against the firewall, shares the same resorvoir as the brake master. Btw, you might want to change the slave cylinder on the tranny at the same time, some folks say that if one goes bad the other should soon as well.
Thread
Thread Starter
Forum
Replies
Last Post