Clutch problem
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Location: Lancaster, PA
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
Clutch problem
We install a GRAB type ACT clutch, well afterward the clutch isn't grabbing. Somehow it is not push all the way in. Is there a solution to fix this at all?
#5
Senior Member
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Location: Lancaster, PA
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
i did have some, but i also was having problem with the wedge staying in place when droping the engine to bolt it into the tranny.
Can i reuse the wedge at all or do each clutch comes with a wedge.
Can i reuse the wedge at all or do each clutch comes with a wedge.
#6
Mr. Links
iTrader: (1)
The wedge collar can be reused. However, if it at all gets even slightly bent out of shape, it won't work and needs to be replace (don't ask how I learned that lesson). The collar is actually two pieces (the ring and the major collar piece). If you had problems with it before, it probably needs to be replaced.
Slide under the car and look through the inspection plate. You should be able to see if the collar is pushed into the pressure plate or not.
Slide under the car and look through the inspection plate. You should be able to see if the collar is pushed into the pressure plate or not.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM