clutch pipe...help!
#1
Rotary Enthusiast
Thread Starter
clutch pipe...help!
Doing the tranny swap and was installing the clutch master cylinder...this was easy hole already there but I also ordered and new clutch pipe. I ordered 2 one for slave and one for master. The salve was easy as the mount to ss flew line was right by the tranny bell housing....but the other hmmmm.
Does the clutch master pipe line go behind the brake drum? if behind the drum, is it under the brake drum or over the brake drum? if not, does it go in front of brake drum? for some reason, couldn't figure it out.
a pic would really help.. and btw, I do have the manual and the manual shows the master with the clutch pipe attached to the top...my clutch master is attaches on the side nor the top for the clutch pipe.
pic? good diagram (from a better manual!)
thank you
going to install motor and tranny this weekend sure hope someone can help.
Does the clutch master pipe line go behind the brake drum? if behind the drum, is it under the brake drum or over the brake drum? if not, does it go in front of brake drum? for some reason, couldn't figure it out.
a pic would really help.. and btw, I do have the manual and the manual shows the master with the clutch pipe attached to the top...my clutch master is attaches on the side nor the top for the clutch pipe.
pic? good diagram (from a better manual!)
thank you
going to install motor and tranny this weekend sure hope someone can help.
#2
Lawn Ornament
man, route it however you want to, i don't have any pictures of my swap up yet, but the rest of it is on my site.. http://ejmack.dyndns.org
I personally bought some metal brake hose from Autozone and bent it an dshaped it against the firewall down to the slave cylinder...
I personally bought some metal brake hose from Autozone and bent it an dshaped it against the firewall down to the slave cylinder...
#3
Rotary Enthusiast
Thread Starter
I have both the oem lines and the ss flex line...
the tips of the clutch pipe have rubber insulation on them. one is close to the nut on the clutch pipe end and the other is further away. I think now the insulator part closes to the flare nut is the one end that attaches to the clutch master??
thanks
the tips of the clutch pipe have rubber insulation on them. one is close to the nut on the clutch pipe end and the other is further away. I think now the insulator part closes to the flare nut is the one end that attaches to the clutch master??
thanks
Thread
Thread Starter
Forum
Replies
Last Post