clutch master cylinder quick question...
#1
Rotary Enthusiast
Thread Starter
Join Date: Feb 2004
Location: New york
Posts: 1,391
Likes: 0
Received 0 Likes
on
0 Posts
clutch master cylinder quick question...
i finally got off my butt to replace my clutch master cylinder.......... it seems like a simple job.. but how do i get to the nuts that keep the master cylinder in place... do i have to go thru the dash?? because that is what it looks like... if u need a pic lemme kno
#2
the job is done from the engine bay. the studs the cylinder sits on stay put.
loosen the line, pb blaster is nice.
then take off the 14 mm (i think)nuts
pull cylinder assembly staright forward
be carefull not to get any brake fluid on your paint. it wil eat it off. if you doo wash it off Immediately
the slave and master tend to go together. dont be suprised if the slave fails next
loosen the line, pb blaster is nice.
then take off the 14 mm (i think)nuts
pull cylinder assembly staright forward
be carefull not to get any brake fluid on your paint. it wil eat it off. if you doo wash it off Immediately
the slave and master tend to go together. dont be suprised if the slave fails next
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM