Clutch adjustment....
08-19-02, 09:41 PM
#1
Lawn Ornament
Thread Starter
Clutch adjustment....
How exactly do i adjust the clutch, The pedal is pretty much dead uintil about 1 1/2 from the floor, then it gets harder to press the rest of the way.... I just got the clutch hydraulics installed, just tryin to make sure everything is workin properly....
08-19-02, 09:50 PM
#2
Hamado things my way!
Join Date: Oct 2001
Location: Pensacola, Florida
Posts: 1,245
Likes: 0
Received 0 Likes
on
0 Posts
First off, you need to lean your seat back and get upside down underneath your dash. 
Then you will need a 17mm, 10mm, 12mm, and maybe a 14 or 15(it's been a while). There are two parts to the adjustment: first you loosen the nut on the clutch switch closest the driver(as oppossed to the firewall), and then turn the switch body itself to bring the pedal closer or further. Next you loosen the nut on the shaft going to the master cylinder. Once it is loose, you turn the shaft to get the appropriate amount of slack. I'm pretty sure Steve Cirian has a description on his site.
Then you will need a 17mm, 10mm, 12mm, and maybe a 14 or 15(it's been a while). There are two parts to the adjustment: first you loosen the nut on the clutch switch closest the driver(as oppossed to the firewall), and then turn the switch body itself to bring the pedal closer or further. Next you loosen the nut on the shaft going to the master cylinder. Once it is loose, you turn the shaft to get the appropriate amount of slack. I'm pretty sure Steve Cirian has a description on his site.
Thread
Thread Starter
Forum
Replies
Last Post