clutch ???
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: balto
Posts: 866
Likes: 0
Received 0 Likes
on
0 Posts
clutch ???
i have the bonez street comp cluth kit already and my question is can i use this pressure plate with a different companies disk ? I would like to get a sprung 6 puck but act nor bonez offers one yet any ideas
#3
Full Member
Join Date: Dec 2004
Location: Pittsburgh
Posts: 147
Likes: 0
Received 0 Likes
on
0 Posts
I current have an ACT street/strip disk with an M2 pressure plate...so...I don't see why not.
I mean, they all have to be the same size. The flywheel diameter is what it is, so the pressure plate has to match. The disk, has really no connection to either, as it floats. So, as long as the disk will fit the tranny splines, you should be good.
I mean, they all have to be the same size. The flywheel diameter is what it is, so the pressure plate has to match. The disk, has really no connection to either, as it floats. So, as long as the disk will fit the tranny splines, you should be good.
#5
Rotary Enthusiast
iTrader: (1)
Join Date: May 2003
Location: Dallas
Posts: 1,464
Likes: 0
Received 0 Likes
on
0 Posts
if its a kit should be included you can technically swap them around on stock type, not sure about twin plates etc.
there is absolutely no point in using a puck clutch if they preassure plate cant handle it.
there is absolutely no point in using a puck clutch if they preassure plate cant handle it.
Thread
Thread Starter
Forum
Replies
Last Post