I've just setup an oil catch can on this single turbo setup, as you can see on in the diagram I've run one line to the oil filler neck ( where PCV used to be ) and the other to a nipple that has already been pre-fabbed into the pipe between the turbo intake and filter. Since this is the only nipple on the intake ( stock twins have 2 ) I've had to use a T-join to ensure both vacume lines are still getting suction from the turbo.
Now i know the one I installed is going to the catch can , can anyone tell me where the other vacume line ( red colored one ) will be going? I looked and its simple going onto a metal hose, but where does that go? and would teeing a line into it for the catch can cause any problems?

 

oil injectors

 

BTW , that vacume hose (red line ) was already on there before I did the catch can install

 

There is an overwhelming amount of oil catch can info on this thread if you haven't seen it yet:
https://www.rx7club.com/showthread.p...hreadid=226214

 

The only problem with this is that the engine sucks all that junk blow-by back into the turbo, IC , TB, UIM, LIM, and engine. It gums up everthing.

Run both hoses from the oil filler neck to the catch can on the sides. Then have the top vent underneath the car. F*** being green!

 

Run both hoses from the oil filler neck to the catch can on the sides. Then have the top vent underneath the car. F*** being green![/QUOTE]


My breather hose (tied to strut brace) is green .....keep things clean. F*** being green as Chuck said.Got a catch can on the shelf but cant find space for it/can't be bothered


[IMG][/IMG]

 

right