edgars95rx7

iTrader: (5)

i recently finished rebuilding my car and i went to turn the key and nothing. I got a couple of connectors that i dont know where or what they go to. i fot 2 black connectors on the ecu side that i dont know what they connect to, i got a white/clear 2 pin connector on the fuse box by the pedals. i also dont have any of the center console warning stuff i dont know if it matters.

things that dont work

no tail lights
no interior lights
i thought maybe a bad ground but i checked all of the grounds and they are all fine
i also connected together the fuse boxes in the engine

cr-rex

iTrader: (114)

if your car was an automatic at one point then those 2 black connectors next to the ecu went to a little computer thing that was there. it was something for AT cars. not relevant if you are MT.

i dont know about the plug next to your fuse box.... a picture maybe?

the most important ground that i found is the one that goes from the hook on the back of the UIM to the firewall. with that ground not connected the car wont even crank.

RotaryEvolution

iTrader: (30)

obviously you did more than just rebuild the engine, think about anything else you did to the car and follow the wiring diagrams.

edgars95rx7

iTrader: (5)

thanks guys really gives me some stuff to look at i will check the uim ground and my car is a MT so i dont need to worry about the black connectors. ill keep you guys posted

edgars95rx7

iTrader: (5)

all grounds are connected and i got nothing but coolant alarm and gauges. still no tail lights or interior lighting.

TpCpLaYa

iTrader: (10)

no tail or interior lights if I'm correct has something to do with the TNS relay/circuit in the fuse block at the front bumper

edgars95rx7

iTrader: (5)

ok thanks ill do some checking