car wont crank (PLEASE HELP)
#1
Full Member
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: ewa hawaii
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
car wont crank (PLEASE HELP)
k i have a 93 rx7 bought as a shell everything just got completed now car wont crank. Cant find the harness comming from ecu to neutral saftey switch. try'd looping the security box by driver side kick pannel. any help would be greatly appreciated pictures would help thanks
#2
Senior Member
iTrader: (1)
Join Date: May 2002
Location: Houston, TX
Posts: 705
Likes: 0
Received 0 Likes
on
0 Posts
This is a simple circuit. Basically the signal starts at the ignition switch, goes to the starter cut relay, then the neutral safety switch, then the starter solenoid.
The starter cut relay is in the driver's side footwell and is controlled by the security system. Jump the two FAT wires in this connector together to bypass the relay and any potential interference from the security system.
The clutch has two switches. The neutral safety switch is the one at the bottom of the pedal stroke, not the top and is not connected to the ECU.
The starter cut relay is in the driver's side footwell and is controlled by the security system. Jump the two FAT wires in this connector together to bypass the relay and any potential interference from the security system.
The clutch has two switches. The neutral safety switch is the one at the bottom of the pedal stroke, not the top and is not connected to the ECU.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM