Brake light "ON" when high boost kicks in
#1
Full Member
Thread Starter
Join Date: Apr 2001
Location: DC Metro
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Brake light "ON" when high boost kicks in
need a lil' help guys. my "BRAKE" light stays on when the cars in high boost. didn't happen before but started few days ago. brake light come on and remained on for a while then it goes out again then comes back on when I floored. Could it be just a fuse or what??? any help will be great thanks!
#4
Full Member
Join Date: May 2001
Location: Frisco, Texas
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
My car did the same thing. If it is not the brake fluid, it could be the emergency brake. It gets loose and under hard acceleration it comes up enough to turn the light on. I had mine adjusted about a year and a half ago and it solved the problem. It feels like it is getting a little loose again already.
#7
Full Member
Thread Starter
Join Date: Apr 2001
Location: DC Metro
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
yeah it's E brake light that comes on. I checked the brake F and it's up at full level. How do I go about adjusting it?? do I adjust inside where e-brake is or under the car??? could I do it my self of take it to the shop???Does it do any harm to the car performance wise or maintance wise??? Thanks for the support guys!!
Trending Topics
#11
Mr. Links
iTrader: (1)
Not a real suggestion, but I had this problem and it ended up being my brake pads.
I agree with the others, check the e-brake first. There was a good post about this about a week or two ago:
I agree with the others, check the e-brake first. There was a good post about this about a week or two ago:
Originally posted by ronarndt
Remove center console section around brake lever and ashtray. Plastic serrated clips hold it in place to the base. Work evenly from front to back around the edge with a wide putty knife or interior trim removal tool so you don't snap the clips off. Brake adjusting nut is accessable once you get the panel out of the way. Loosen nut to loosen brake, tighten nut to tighten brake. Check to make sure your parking brake warning light is off when brake is released and on when brake is applied.
Remove center console section around brake lever and ashtray. Plastic serrated clips hold it in place to the base. Work evenly from front to back around the edge with a wide putty knife or interior trim removal tool so you don't snap the clips off. Brake adjusting nut is accessable once you get the panel out of the way. Loosen nut to loosen brake, tighten nut to tighten brake. Check to make sure your parking brake warning light is off when brake is released and on when brake is applied.
Thread
Thread Starter
Forum
Replies
Last Post