Boost Problem
Thread Starter
Full Member
Joined: Mar 2001
Posts: 70
Likes: 0
From: Jersey Shore
Boost Problem
Ok, here's the deal. New replacement motor that was kept at max boost (6lbs) for 1000 mi break-in. I installed a Profec B today, and with boost dial turned all the way down I get the correct 6lbs of boost. But, when I attempt to calibrate the Profec (WOT in 4th) I can't get any more boost than 6lbs. I'm stuck in 6lb. hell! I followed the Profec install directions to a tee on the Rob's site. Any ideas? Thanks....
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
Mar 15, 2022 12:04 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
AXA
Single Turbo RX-7's
8
Sep 5, 2015 10:06 AM
tiger18
3rd Generation Specific (1993-2002)
9
Sep 3, 2015 08:27 PM