Boost controller question
12-13-01, 12:24 AM
#1
Rotary Freak
Thread Starter
Boost controller question
I'm currently runngin a dawes device boost controller w/ a pre-spool valve. When I get an electronic boost controller do I need to take the dawes and pre-spool vavle out and replace them with the stock lines with the pills in them, or does the EBC motor replace those lines? Or, does the motor placement depend on what EBC it is? EBCs use motors in the lines right?
12-13-01, 12:46 AM
#2
Full Member
Join Date: Mar 2001
Location: SoCA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
EBC solenoid between the line coming from the manifold to the wastegate, controls primary turbo very well.
I kept my home depot prespool valve, and screwed around with it to get something like 13-11-13, with boost creep up to 14. You can try a second EBC at this line if you got cash, but I don't think it's worth it.
I kept my home depot prespool valve, and screwed around with it to get something like 13-11-13, with boost creep up to 14. You can try a second EBC at this line if you got cash, but I don't think it's worth it.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM