Boost in 1st
#1
Boost in 1st
I know this problem has been talked about over and over for stock twins but I'm not sure if my problem is a little different. I'm still on stock sequential twins, with full 3" exhaust and no air pump HKS RS intakes and HKS v-mount. Apexi PFC computer using the stock boost control. I am not getting the boost creep problem at all with this setup and am getting the perfect 9/7/9 (or whatever it is it's been a while since i looked) transition in every gear except first. If i go full throttle in first i am pulling vacuum by 6k unless i only give around half to 3/4 throttle and then it will actually boost. I've checked all couplers and have no boost leaks and am a day away from tearing into it and changing the typical solenoid that people say causes this problem, if anyone else has seen this am I going to waste my time? TIA
Thread
Thread Starter
Forum
Replies
Last Post
axnjaksn
3rd Generation Specific (1993-2002)
2
04-13-08 08:51 PM
rexhvn
3rd Generation Specific (1993-2002)
6
05-23-07 02:22 PM
Decay
3rd Generation Specific (1993-2002)
1
05-20-03 10:00 PM
tran
3rd Generation Specific (1993-2002)
1
11-03-02 10:41 AM
jimmyv13
2nd Generation Specific (1986-1992)
16
07-09-02 01:39 AM