Blitz SBC III ID Settings for SEQ twins
#1
Blitz SBC III ID Settings for SEQ twins
Okay, ive done a couple of searches and got some different results. Some say you can use manual mode some say you need to use AUTO. The only thread that was on the blitz settings was for single turbo rx7. I am running the stock seq twins, what do I set my gain to?? How do i proprely set it? And the ratio is how many psi I want to run correct? Is their any harm running 11psi? My mods are intake dp exhaust, no aftermarket ecu. Thanks for any help.
bryan
bryan
#2
Big Daddy!!!
Join Date: Jul 2002
Location: Edmonton, Alberta, Canada
Posts: 1,194
Likes: 0
Received 0 Likes
on
0 Posts
You use the manual mode. The auto mode is for a single turbo application. The gain on the controller is used to moderate the boost spike when the second turbo comes on line. I used to have it set perfect so that I would get about a .25psi spike at transition. I seem to remember that 10psi was in the mid 20's but I can't remember the gain setting.
R.K.
R.K.
#3
Big Daddy!!!
Join Date: Jul 2002
Location: Edmonton, Alberta, Canada
Posts: 1,194
Likes: 0
Received 0 Likes
on
0 Posts
Just set the boost level first and then play around with the gain. Start on the low end of the ratio that way you won't over boost. You sould be fine at 11psi with your mods. Just keep you boost spike to a minimum to avoid boost cut or your motor going. Good luck.
R.K.
R.K.