Bleed fuel system??
06-03-04, 06:03 PM
#1
Full Member
Thread Starter
Join Date: Feb 2002
Location: Texas
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Bleed fuel system??
I just got my car together after 18 months!!
I installed a new FP, SXFPR, rail, B&G Fuel Filter and 1,600's. Don't I need to bleed the air out of the system? If so, any tips?
I installed a new FP, SXFPR, rail, B&G Fuel Filter and 1,600's. Don't I need to bleed the air out of the system? If so, any tips?
06-03-04, 06:55 PM
#2
I'm a CF and poop smith
you do no need to really bleed the air out, you just prime the system by jumping the fuel pump.
you do this by connecting a wire betewen the ground and the f/p (fuel pump) connectors in the engine bay diagonistic box and turning the car to the on position, wait about 10-30 secs and disconnect it (pull out the wire). check for leaks and then if there are none, start her up. she should just fire right up if everything is ok.
you do this by connecting a wire betewen the ground and the f/p (fuel pump) connectors in the engine bay diagonistic box and turning the car to the on position, wait about 10-30 secs and disconnect it (pull out the wire). check for leaks and then if there are none, start her up. she should just fire right up if everything is ok.
Thread
Thread Starter
Forum
Replies
Last Post
Snook
3rd Generation Specific (1993-2002)
21
09-01-15 06:32 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM