ok, i just spent too much time trying to find a hole in the firewall to run my battery cable through. how do you guys route the positive cable from the rear bin to the engine compartment? do you run it under the car? drill a hole in the firewall or what??
thanx

 

drill......

 

there's a big huge hole that goes from the side of the engine bay underneath the cruise control stuff....by the wheel well and into another hole underneath the driver's side dash. do a search on the forum for battery relocation.

 

OK, BUT DO I NEED TO REMOVE THE FENDER TO ROUTE IT THROUGH THAT HOLE? I FOUND THAT HOLE THAT LEADS TO THE INSIDE OF THE FENDER, BUT I DONT SEE THE ONE THAT LEADS BACK IONTO THE CABIN. YTHERE IS A GROMMET BY WHERE THE DOOR SPEAKER WIRES GO THROUGH, BUT IT'S NOT USEABLE BECAUSE THERE IS A LARGE PLUG IN THE HOLE. EXCUSE THE CAPS, THANX

 

there is a hole underneath the cruize control for the touring people, and just a plain hole for everyone else behind the pillowmounts for the suspension (shock tower). Now, Jack up your car and remove the wheel well ligning. You can remove the right side of the well only and bend it back, now look to find that hole that i jsut talked about and there is another hole about 4 inches from that. Its got already a Round Grommet/Cap thats about 3 inchs in diameter, use that hole to route your + wire. The hole is right behind your Fuse box right by the dead pedal in the cockpit of your car. Help this helps some
Huy

 

I SEE IT, THANX EVERYBODY

 

I connected the positive cabel to the starter and ran it underneath to where the rear bins sit. Then drilled a hole and ran it through. Grounded to the door where the sensor detects if it is closed or not...cant miss it.