AWS solwnoid
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: May 2001
Location: Clemson, SC
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
AWS solwnoid
can anybody tell me exactly where the electrical connector for the AWS is? i know that it's on the passenger side of the engine bay, but i'm not sure exactly which wire it is. there's a connector then a wire that leads to the o2 sensor, but i dont think that this is it. there is another wire that goes directly under the UIM, is this one it? I talked to Jason, and he said it was one of these two, but i'm not sure which one. thanks guys, Russell
#2
There and back again
Join Date: Feb 2001
Location: Camarillo, Ca
Posts: 967
Likes: 0
Received 0 Likes
on
0 Posts
Two ways to get to it.
a. follow the 1" hose from the plastic intake elbow (Connects to the AWZ) or..
b. Draw a straight line pointing down from the double throttle actuator.
Any way you look at it, it is a bit tight for large hands to move around, but the harness can be unplugged and plugged back in without taking off the throttle body.
a. follow the 1" hose from the plastic intake elbow (Connects to the AWZ) or..
b. Draw a straight line pointing down from the double throttle actuator.
Any way you look at it, it is a bit tight for large hands to move around, but the harness can be unplugged and plugged back in without taking off the throttle body.
#3
Full Member
Join Date: Feb 2001
Location: Austin, Texas, USA!
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Won't you have trouble code (check engine light) come on if you disconnect the solenoid? I just made a block off plate for mine, and kept everything looking stock. However I still get a cold engine rev to about 2000 rpm until warm up is complete. It doesn't bother me, I just thought it would idle at 800 rpm cold after I disabled the AWS system. Anyone care to comment?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM