automatic transmission problems
#1
Newbie
Thread Starter
Join Date: Sep 2006
Location: CHARLOTTE, NC
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
automatic transmission problems
Check engine light is on, car will not go into overdrive and hold button does not work. Tried to run diagnostic check and no code was pulled concluding that there may be an electrical problem. Has anyone experienced this and, if so, what is the appropriate solution.
#2
Is your hold light flashing? this is what indicates a transmission problem...sounds like it is "stuck" in hold with the overdrive not engaging...
The check engine light indicates an engine problem......
be sure you are checking for the right codes (ie. engine diagnostic/vs trans.diagnostic)
The check engine light indicates an engine problem......
be sure you are checking for the right codes (ie. engine diagnostic/vs trans.diagnostic)
#4
Constant threat
I am not sure how your CEL is on but you can get no code.....? Not to ask the obvious but...are you grounding the ten pin correctly and turning the ignition to 'on'?
Also, have you tried just disconnecting the battery and pressing on the brake, resetting the ECU? You might try that just for grins if you haven't.
If it the problem is transmission related, you will usually have the 'hold' light flashing, as stated previously by BigAl.
Also, have you tried just disconnecting the battery and pressing on the brake, resetting the ECU? You might try that just for grins if you haven't.
If it the problem is transmission related, you will usually have the 'hold' light flashing, as stated previously by BigAl.
Thread
Thread Starter
Forum
Replies
Last Post