automatic engine conversion
automatic engine conversion
I am converting an engine from an automatic FD to stick-shift duty.
Is there a flywheel that will bolt-on using the automatic's flywheel flex-plate mount but still work with my manual tranny ?
In short, I don't want to crack/loosen that large 54mm nut for the eccentric shaft just to replace the flywheel.
And if I can get a slightly lighter one, so much the better.
:-) neil
Is there a flywheel that will bolt-on using the automatic's flywheel flex-plate mount but still work with my manual tranny ?
In short, I don't want to crack/loosen that large 54mm nut for the eccentric shaft just to replace the flywheel.
And if I can get a slightly lighter one, so much the better.
:-) neil
Last edited by M104-AMG; Jan 5, 2005 at 04:43 PM.
"Challenged" since 1993
Joined: Sep 2002
Posts: 540
Likes: 0
From: Columbus, Oh
Any lightened flywheel uses the Auto. counterweight. Just unbolt the flex plate and bolt the lightened flywheel in its place.
http://www.rx7store.net/index.asp?Pa...rodID=824&HS=1
http://www.rx7store.net/index.asp?Pa...rodID=824&HS=1
Last edited by Rotarded; Jan 5, 2005 at 04:46 PM.
"Challenged" since 1993
Joined: Sep 2002
Posts: 540
Likes: 0
From: Columbus, Oh
Originally Posted by M104-AMG
If I use the stock 5-speed flywheel, I'll have to crack the nut, correct ?
:-) neil
:-) neil
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM
