so there are a number of threads out there on doing tranny swap. all confusing as hell.

according to MOBEONER, the auto harness clips will fit the manual tranny. The only harness that will need to be modified is the auto tranny shifter harness. That harness affects the clutch pedal switch and reverse lights. once wired correctly you are good.

have anyone done this before? there are only 3 connectors from the engine harness but the transmission have 4 connectors? how would i need to modify it to work with reverse light?

 

anyone?

 

I would like to know the answer to this. I have read post after post and none of the details given make the back up lights work. Rix

 

I was confused me to until i deceided to just buy a set of wired from an manuel FD. It cost me about 600$ used for the front main harness, the ''inside firewall harness" and the dash harness. I have now a real manuel car with no mess wired

Fritz Flynn have a couple of harness if you deceided to go thi way!

I hope this will help you!

Eric

 

There is away to cut the auto harness clips and install them onto the manual harness but you gotta use the search function..

 

hahahaha

 

there is no post on converting auto plugs to match tranny plugs. i've searched and pmed people but no good response.. anyway. i just end up using my old USDM harness... thanks.