auto to 5 speed question.
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2011
Location: Albuquerque, NM
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
auto to 5 speed question.
I know its probably been covered before but I am trying to figure this out. I have a 5 speed harness on my engine going into the car, and the rest of the harness in the car is from all the automatic, is there any way to get this wired up to work without changing the whole front "ring" harness?
Thanks
Thanks
#2
Senior Member
iTrader: (1)
Yes you can use your manual emissions harness with the automatic dash harness. But you will need to find an X-14 and X-05 from an automatic emissions harness and replace these two connectors on your manual harness. There are a number of wires which will need to be re-routed to the new connectors but everything will work. Your new clutch switch will need to be brought into the new X-05 and you will need to make a tie between X-14 and X-05 to support a cluster ground.
Probably more information than you wanted so the short story is it all works.
Probably more information than you wanted so the short story is it all works.
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2011
Location: Albuquerque, NM
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Actually no thats awesome, thanks a ton, I have a spare auto harness that got a little crispy in the in engine bay, so all the wire connectors and plugs that were by the ECU are in good shape So I can use those.
Thanks a bunch!
Thanks a bunch!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
edmcguirk
NE RX-7 Forum
3
05-30-18 06:50 PM