Auto to 5-spd. IV SEARCHED!
#1
Damn I broke his neck!
Thread Starter
Join Date: Nov 2004
Location: Clermont FL
Posts: 869
Likes: 0
Received 0 Likes
on
0 Posts
Auto to 5-spd. IV SEARCHED!
Ok, for the past week or so ive been searching for a GUIDE/STEP-BY-STEP thing for a tranny swap. iv found alot of things on prices and what parts u need, but nothing on how to do it. anyone know where i can find one? or is anyone willing to write one? ill host it up in a domain for anyone else who is in the same position as me as well.
#2
Rotary Enthusiast
Join Date: Jun 2004
Location: Gallatin, TN
Posts: 1,457
Likes: 0
Received 0 Likes
on
0 Posts
I found these by searching...
https://www.rx7club.com/showthread.p...6&page=1&pp=15
https://www.rx7club.com/showthread.p...2&page=1&pp=15
If you already know what you'll need then just go a few pages ahead and it should get into problems you may run into and so on.
-Alex
https://www.rx7club.com/showthread.p...6&page=1&pp=15
https://www.rx7club.com/showthread.p...2&page=1&pp=15
If you already know what you'll need then just go a few pages ahead and it should get into problems you may run into and so on.
-Alex
#3
Lawn Ornament
You unbolt the parts and bolt the other parts on.... there is how to's on installing a fly wheel, clutch, and other various parts...
There is also a wiring diagram for the conversion....
You must not have searched that hard
There is also a wiring diagram for the conversion....
You must not have searched that hard
#4
TRINGLS
Join Date: Apr 2004
Location: Clermont, FL
Posts: 1,053
Likes: 0
Received 0 Likes
on
0 Posts
Manny, you should of asked me to send you some links... beyond the extensive knowledge of Ejmack and a couple others who have swapped I made a post comprising more info and links:
https://www.rx7club.com/showthread.p...ighlight=at%2A
Also to be noted, I think one side bolt doesnt line up and one top bolt doesnt line up... I still dont have my flexplate off so I cant say for sure yet but that is what I've gathered from eying it.
~Kris
https://www.rx7club.com/showthread.p...ighlight=at%2A
Also to be noted, I think one side bolt doesnt line up and one top bolt doesnt line up... I still dont have my flexplate off so I cant say for sure yet but that is what I've gathered from eying it.
~Kris
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM