Who can shoot me the instructions on the power fc or tell me which pins to remove on the ECU?
Thanks

 

https://www.rx7club.com/power-fc-forum-47/new-version-powerfc-faq-573647/

 

Thanks

 

for which series is the pin removal required?

 

do NOT remove the pins. Removing the pins voids whatever warranty you may have. You're much better off cutting the wires.....I use heat shrink on the exposed ends to insulate them.

 

I wouldnt even cut the wires, you can pull the female pins out of the harness and heat shrink them to insulate. Its a bit of a pain to remove them but it makes things much easier if for some reason you ever decide to put it back to stock.

 

I have always felt that pulling pins out of an electronic units circuit board is plain stupid.


Later