Tried doing a search but came up negative. Anybody running their FULLY converted non sequential turbos with an apexi avcr boost controller? If so, what were your impressions and what must me done/hooked up differently to the turbos?? I have it hooked up to my stock sequential twins right now. Thanks a bunch.

 

How does it run? I'm not sure what you're looking for there. How about fine.

As far as hooking it up, run a vaccum line from a nipple on the primary snail to the NO port on the solenoid valve. Then from the COM port to the wastegate actuator. Plug the second nipple on the wastegate actuator.

 

If I remember correctly, when I was looking into BOV's, the AVC-R is a good choice for non-sequential and the profecB spec 2 is good for sequential. As far as set-up goes... can't help you out much there as I am running a manual boost controller

 

I mean not BOV's... boost controllers

 

thanks..i'll look into it when i do the install