I recently installed a new engine in my car, and put in a few new goodies while i was at it. among these mods was the Apex'i fmic with intakes. the only prob is, they use the hard piping and the rear turbo filter tube mounts where the BOV is supposed to mount. my question is, has anyone found a good place to put that damn thing? i didn't really wanna have to weld my ic pipes, but i guess i might have to

 

the BOV hose is beside the secondary turbo inlet pipe. no welding needed. you may want to re-check you intake installation.

 

i would think if i can install an engine, i'd know where the bov tube is. what i'm tryin to say, is the adapter to use the Apex bov for the FD, mounts on the passenger side of the engine bay. the location that it mounts to is also the same location that the hard pipe for the secondary turbo mounts to. i was just needing to know if anyone else has these 2 parts and what they did to resolve this issue, i can't really find a good place to mount the bov

 

Unfortunately, I think most people do what you don't want to do.... weld it...