anyone have problems with this setup?
#1
Full Member
Thread Starter
Join Date: Feb 2002
Location: Monterey Park, CA
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
anyone have problems with this setup?
I'm running an Apex FMIC and HKS dp. I'm worried about boost creeps and what not. What I want to know is if anyone out there has had problems running with just these mods without a pfc. PFC is in the near future as well as a catback (whenever they get in stock), but for the time being I'll just be running those 2 mods.
#2
Senior Member
Join Date: Dec 2001
Location: Crestview, FL
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
I agree that you should try a plastic welder. A company called Harbor Freight (in Roanoke, VA) has them. I think they had welders for around $30 to $60, but then you needed to have at least a small air compresser (usually runs for about $100 or so). All I could find on there website was another type of plastic welder though.
http://www.harborfreight.com/cpi/cta...emnumber=45528
They seem like a pretty large company and they may have something near you in PA.
http://www.harborfreight.com/cpi/cta...emnumber=45528
They seem like a pretty large company and they may have something near you in PA.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM