3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Another headlight problem

Thread Tools
 
Search this Thread
 
Old Sep 13, 2008 | 09:14 PM
  #1  
muibubbles's Avatar
Thread Starter
Bubblicious DEF.
Tenured Member: 15 Years
iTrader: (36)
 
Joined: May 2008
Posts: 4,273
Likes: 10
From: 732
Another headlight problem

first i searched, nothign seems compatable...

okay so i was driving the car back from IL.. headlights worked without a problem.. when i was in ohio the driver side headlight wont retract...

Problem:
Driver side headlight it stuck up.
When i press the retract button on the dash only the passenger side headlight goes up and down

Diagnosed...
I've been looking at the workshop manual and ive checked..
The retractable headlight relay (E1-02) in the relay box, looked fine
The Headlight relay (E1-05) in the Main Fuse Block, looked fine

Analysis:
The headlights were retracting without a problem then all of a sudden the driver side headlight wont retract.
Lights on both sides work without a problem

any suggestions? ive read check the power source to make sure its getting voltage and check the motor but im not sure how to do either...

to check the volt do i use a digital multi meter or one of those stick things that clip to a ground and you touch the connection and it lights up?

also what should i be checking with those? please be specific as im unsure of further diagnosing

-benny
Reply
Old Sep 14, 2008 | 11:17 AM
  #2  
muibubbles's Avatar
Thread Starter
Bubblicious DEF.
Tenured Member: 15 Years
iTrader: (36)
 
Joined: May 2008
Posts: 4,273
Likes: 10
From: 732
=( help!
Reply
Old Sep 14, 2008 | 11:25 AM
  #3  
1QWIK7's Avatar
White chicks > *
Tenured Member: 20 Years
iTrader: (33)
 
Joined: Jul 2003
Posts: 13,147
Likes: 1
From: Secaucus, New Jersey
You can use a multimeter or a test light.

And when you checked your relays, how do they "look" fine?

You have to add volts to it to hear a "click" to see if its opening the circuit.

How far are you, maybe i can come help you out.
Reply
Old Sep 14, 2008 | 04:54 PM
  #4  
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 1,083
Likes: 4
From: california
I have the same problem only on pass side. off and on without warning I think it may be a wiring problem with the underhood heat. I've noticed the relays get very hot even with the rubber boot covers to shield them. I am open for advice on how to trouble shoot this

Jeff
Reply
Old Sep 15, 2008 | 04:44 AM
  #5  
Speedworks's Avatar
Rotary Freak
Tenured Member 20 Years
 
Joined: Jan 2004
Posts: 1,890
Likes: 4
From: Belgium
Similar problems here:


My passenger light pops up when engaging the headlights., but won't come down when tuning them off.

I checked the headlamp motors with direct power feed and then they work fine; probably a relais issue.


my driver side headlamp won't go up or down but I found some kind of a shortcut in the pop up motor. might need to replace that.

The worksshop manual mentions some kind of an ECU that controls all this, but I haven't locatee it yet. anyone got a clue?

Also, my manual pop up button does not function.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
The1Sun
1st Generation Specific (1979-1985)
0
Sep 7, 2015 10:21 PM
<<Ayrton>>
Interior / Exterior / Audio
0
Sep 5, 2015 09:38 PM




All times are GMT -5. The time now is 03:14 AM.