Almost there
#1
I'm sorry wha?
Thread Starter
Almost there
After almost a little more then a year of slacking, working, l earnning,bleeding, sweating, arguing fighting, and tearing my RX-7 is almost finished. As of ow it is sittin ghere in my garage at home and the engine and trany are almost completely assembled right next to it....Chances of it workign when it all goes back in....ha wish I knew. But the real question is, will some one explain how to post pics, becasue this is a fairly long intresting project that I would like to share with the community and get feed back on. The most important part. There is a little metal tube that comes off of the rotor housing where the oil is poured in.....WHAT THE BLOODY F@#K does that conect to? I cant find iit anywhere on my hose diagrams or manuals. If this is a retarded question I apologize....Can anyone diagram this for me? this is the only hose left that is baffelig the living crap out of me.
xeros
xeros
#3
RX-7 Bad Ass
iTrader: (55)
It's for the PCV system. Should be on the hose diagrams and whatnot.
Dale
Dale
#4
development
only metal tube I can think of is for the PCV...a line attaches to the metal tube than to the plastic tube on the filler neck (pointing down), on the other end of the metal tube, a line attaches to the primary inlet...assuming you have twins.
#5
I'm sorry wha?
Thread Starter
no no no right off the rotor housing where the filler neck attaches, to the right of it is a metal tube coming off of it, because my filler neck is already attached to the appropriate PCV valve....seriously....doesn't anyone know what I am talkin about?
#6
I'm sorry wha?
Thread Starter
OH WEIRD ***! I judt looked at James Paventi's rebuild pics....and his 13b doesnt have the metal tube i do coming right off the rotor housing filler tube connector.......