Is replaceing a stud for the ACV on the lower intake manifold as easy as some of the other studs (i.e. WD40 and back it out with vise grips)? I had one snap off when putting things back together today (I was using a torque wrench set to 14 ft/lbs but hadn't gotten to spec yet).

Is there an aftermarket stud that will work or do I need to order one from Mazda?


Thx,
Jon

 

Order a new one from Mazda... Your not supposed to reuse the studs... Mazda recommends they be replaced should you have occassion to remove the nut... which usually welds itself to the stud anyway<<< both come out together>>

 

I'd buy one from Mazda, but you could probably go to a hardware store and buy a good quality bolt.

It should come out easily with vise grips.